[LinuxFailSafe] stonith

[Lars Marowsky-Bree]

On 2002-04-30T00:49:40,
   Nemeth Lorant <loci@crandon.sch.bme.hu> said:

> I defined to nodes, put them into a cluster, defined two failover plocies, 
> to IP_addresses and 2 resource groups (one for one IP, the other for the 
> other IP). I've get these errors:

Did you do "Start HA services"? (Or haActivate from the commandline)

> Other thing:
> 
> I've got a WTI RPS-10 power switch. I installled the heartbeat-stonith rpm 
> from the linux-ha.org website. 
> 
> I typed:
> 
> stonith -t rps10 -p "/dev/ttyS0 labpc2 0" labpc2
> 
> It said smoething, that it doesn't get the response 'WTI RPS-10 Ready' or 
> something like that. I took a look at the documentation, but I couldn't 
> find any commands on which the switch should reply this. May this be a 
> bug, or I did smoething wrong (the source code for rps10.so sais it's for 
> rps-19 M switches, and i've got the EC type i think (for 230V))

If it doesn't get the WTI RPS-10 Ready string, my crystal orb tells me that
your serial cable which you used to connect the power switch does not
correctly connect the pins necessary for hardware flow control.

Please get a fully wired cable.

If that is a wrong guess, you may have incorrectly configured your power
switch; you should have set it to 9600bps.


Sincerely,
    Lars Marowsky-Brée <lmb@suse.de>

-- 
Immortality is an adequate definition of high availability for me.
	--- Gregory F. Pfister