[Linux-HA] STONITH keeps rebooting node over and over

[David S. Madole]

I have setup STONITH on my two-node cluster using a Baytech RPC-3 as the underlying hardware.
 
It works in that if node B fails, then node A performs a power cycle on it. However, it continues to power-cycle the node every 30 seconds or so and node B never gets a chance to come back up again.
 
I have been searching for a setting to change the amount of time that node A waits for node B to become available before killing it again but I can't find anything. A way to make it only try once even if node B does not come up would be fine also, after all if it doesn't come back after one power cycle, it's not likely to after ten either.
 
Any tips?
 
David