[Linux-ha-dev] Ordering of OCF Start, Stop and Monitor actions

[Andrew Beekhof]

On 3/29/07, Doug Knight <dknight at wsi.com> wrote:
>
>  I went ahead and installed via RPM automake, autoconf, and libtool, even
> though they were not needed for the 2.0.8 baseline build (I believe libtool
> at least may have been installed previously). ConfigureMe bootstrap ran
> fine. From the output I gather it includes the equivalent of the ConfigureMe
> configure run, and now I just need to do the make?

right

>
>  Doug
>
>  On Thu, 2007-03-29 at 09:23 -0400, Doug Knight wrote:
>
>  OK, Tried that, no luck. It still complains about libtool, autoconf, and
> automake. When I copy over the same basic files from the 2.0.8 directory,
> bootstrap still does not work, but ConfigureMe configure does (at least to
> the point where it starts looking for the Makefile.in files).
>
>  Doug
>
>  On Thu, 2007-03-29 at 09:50 +0200, Andrew Beekhof wrote:
>  pretty sure you need:
>  ./ConfigureMe bootstrap
>
> On 3/28/07, Doug Knight <dknight at wsi.com> wrote:
> >
> > Alan and Lars,
> > After much effort, I have had no success in building from the mercurial
> > version. Here's what I tried, and since this is the first time I've tried
> to
> > build a dev version, maybe you can see where I'm going wrong:
> >
> > Downloaded tar from hg.linux-ha.org/dev
> > Unpacked it in a subdirectory to my root account, HA
> > Attempted a quick ConfigureMe configure, got errors that it couldn't find
> > libtool, automake, autoconf
> > Did a side-by-side comparison to the HA 2.0.8 I built successfully and am
> > running with, found no libltdl.tar or libltdl directory under the dev
> > version. Copied these from my original stable release tar into the
> directory
> > structure for the dev version.
> > Ran ConfigureMe configure, which then complained about all the Makefile.in
> > files missing. Copied those over as well from the side-by-side. Also
> pulled
> > include/ha_config.h.in and linux-ha/config.h.in since it complained about
> > those missing too.
> > ConfigureMe configure runs to completion
> > ConfigureMe make exits with the following:
> >
> > In file included from base64.c:18:
> > ../../include/heartbeat.h:38:23: error: hb_config.h: No
> > such file or directory
> > ../../include/heartbeat.h:98:1: error: "HB_RC_DIR" redefined
> > In file included from ../../include/lha_internal.h:37,
> > from base64.c:17:
> > ../../linux-ha/config.h:504:1: error: this is the location of the previous
> > definition
> > In file included from base64.c:18:
> > ../../include/heartbeat.h:102:1: error: "HALIB" redefined
> > <command line>:1:1: error: this is the location of the previous definition
> > gmake[2]: *** [base64.lo] Error 1
> > gmake[2]: Leaving directory
> > `/root/HA/Heartbeat-Dev-829e377e00bd/lib/clplumbing'
> > gmake[1]: *** [all-recursive] Error 1
> > gmake[1]: Leaving directory
> > `/root/HA/Heartbeat-Dev-829e377e00bd/lib'
> > gmake: *** [all-recursive] Error 1
> >
> >
> > Any ideas?
> >
> > Doug
> >
> >
> >
> > On Sun, 2007-03-25 at 16:06 -0600, Alan Robertson wrote:
> > Doug Knight wrote:
> > > Got it. The attached file contains the strace from the second attempt by
> > > heartbeat to start the resource up as master, right up until it was
> > > killed. The resource already showed failed on the gui. I zipped it up
> > > using gzip.
> >
> > Lars asked a good question as well...
> >
> > Could you kindly reproduce this with the current Mercurial tip version?
> >
> > Thanks1
> >
> >
> >
> > _______________________________________________________
> > Linux-HA-Dev: Linux-HA-Dev at lists.linux-ha.org
> > http://lists.linux-ha.org/mailman/listinfo/linux-ha-dev
> > Home Page: http://linux-ha.org/
> >
> >
> _______________________________________________________
> Linux-HA-Dev: Linux-HA-Dev at lists.linux-ha.org
> http://lists.linux-ha.org/mailman/listinfo/linux-ha-dev
> Home Page: http://linux-ha.org/
>
>
>  _______________________________________________________
> Linux-HA-Dev: Linux-HA-Dev at lists.linux-ha.org
> http://lists.linux-ha.org/mailman/listinfo/linux-ha-dev
> Home Page: http://linux-ha.org/
>
>
> _______________________________________________________
> Linux-HA-Dev: Linux-HA-Dev at lists.linux-ha.org
> http://lists.linux-ha.org/mailman/listinfo/linux-ha-dev
> Home Page: http://linux-ha.org/
>
>